Difference between revisions of "Template:ETH-USB-HUB-HAT-manual"

From ingcool
Jump to: navigation, search
(创建页面,内容为“===使用步骤=== *将ETH/USB HUB HAT插入到Raspberry Pi Zero/ Zero W的40PIN引脚上。 *将USB转接头连接模块的micro USB接口和树莓派的OTG接口…”)
 
(=Interfaces)
 
(One intermediate revision by the same user not shown)
Line 1: Line 1:
===使用步骤===
+
===How to use it===
*将ETH/USB HUB HAT插入到Raspberry Pi Zero/ Zero W的40PIN引脚上。
+
*Insert the ETH/USB HUB HAT to Raspberry Pi. Connect USB interface of Raspberry Pi to micro USB interface of ETH/USB HUB HAT
*将USB转接头连接模块的micro USB接口和树莓派的OTG接口。
+
*Connect Network cable to RJ45 interface of ETH/USB HUB HAT
*给树莓派上电,PWR指示灯会亮起
+
*Power on Raspberry Pi. PWR indicator lights on and ACT indicator is flashing. Now you can check the network and USB ports
*将网线接入模块的RJ45接口,ACT灯闪烁
+
*When USB devices are connected to USB1~USB3 ports, related LED D1-D3 light on
*将USB设备连接模块上的USB1~USB3接口,对应的指示灯D1~D3会亮起
+
===Interfaces===
===接口说明===
+
*USB: USB interface, should be connected to USB port of Raspberry Pi
*USB: Micro USB接口可以接入到树莓派的USB (OTG)接口
+
*USB1 ~ USB3:Extended USB ports, can be connected to external USB devices
*USB1 ~ USB3:USB扩展端口,可以接USB设备
+
*ETH:RJ45 port, can be connect to wired network
*ETH:RJ45网卡接口,可以接入有限网络
 

Latest revision as of 16:34, 8 June 2020

How to use it

  • Insert the ETH/USB HUB HAT to Raspberry Pi. Connect USB interface of Raspberry Pi to micro USB interface of ETH/USB HUB HAT
  • Connect Network cable to RJ45 interface of ETH/USB HUB HAT
  • Power on Raspberry Pi. PWR indicator lights on and ACT indicator is flashing. Now you can check the network and USB ports
  • When USB devices are connected to USB1~USB3 ports, related LED D1-D3 light on

Interfaces

  • USB: USB interface, should be connected to USB port of Raspberry Pi
  • USB1 ~ USB3:Extended USB ports, can be connected to external USB devices
  • ETH:RJ45 port, can be connect to wired network